Quote:
Originally Posted by dag19
Those are my thoughts as well tasian. I think that is what I am going to try first and foremost. I looked at getting a set of lowering leafs from CPP but those are a cool 3 hundo. I'll pass. Where do you get the "Easy Rider" springs at?
|
Here's a tip if u decide to remove a couple leaves....if they dont already have poly rub blocks on the ends u can take a grinder and "carefully" taper the sharp edge of the spring about 3/8 of an inch in ....this is where most all the friction happens which often results in a rough ride
When the suspension goes up and down the leaves slide against each other because the arch becomes less under compression ...lengthening the pack between the eyes.
Any thing u can do to make them slide easier will result in a a smoother ride ...iv'e even put a little grease in between the leaves at the ends to reduce friction....its cheap and easy ...give it a try .....TTYL