View Single Post
Old 08-03-2012, 08:35 AM   #8
Hertzdaddy
Registered User
 
Join Date: Oct 2008
Location: Montpelier, VA
Posts: 315
Re: Calling all "Double Hump" crossmembers.

Quote:
Originally Posted by J Knight View Post
They bolt to the inside of the frame flange on both sides just like your current crossmember does on the right side. I don't know if its advisable or not to go without top braces but like I said, I didn't have any problems when I did it.
Posted via Mobile Device
I suppose you could flip the x-member upside down and bolt it to the bottom of the frame rail, weld the uppers to the underside (now facing up) and maybe have enough room to pass the exhaust between the upper and recessed area on the flipped x-member.

I'd like to see a pic of the 3/4 x-member installed too.
Hertzdaddy is offline   Reply With Quote