The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - Horn contact pin/spring/plastic thingy order?

**landy** · 08-14-2012, 02:34 PM

Included in the LMC kit, there should be a gray fiber-like barrel shaped piece with protrusions or nipples on the sides. In order to make this piece work, you'll need to gently grind/sand down the protrustions so that it seats inside of the cylinder or void on the cancelling cam. The barrel shaped piece is intended to keep the spring and pin from popping out of the cylinder. However, you'll need to expoxy or JB Weld it into the top of the cylinder.

See my previous posts and links for additional clarification.

08-14-2012, 02:34 PM	#8
landy Senior Member Join Date: Jun 2000 Location: alb, nm Posts: 413	Re: Horn contact pin/spring/plastic thingy order? Included in the LMC kit, there should be a gray fiber-like barrel shaped piece with protrusions or nipples on the sides. In order to make this piece work, you'll need to gently grind/sand down the protrustions so that it seats inside of the cylinder or void on the cancelling cam. The barrel shaped piece is intended to keep the spring and pin from popping out of the cylinder. However, you'll need to expoxy or JB Weld it into the top of the cylinder. See my previous posts and links for additional clarification.