|
Re: To pull the trans or not? That is the ?
The "Detent Cable" actually is not that hard to change. You unbolt the cable at the trans. case and pull it out against the internal full throttle stop. Hold the clip and detach the cable end. Attach the new cable, insert into case and install retainer bolt. If you are trying to do this in the truck fish the cable up after it is attached to the trans.. Be aware there is a service procedure for adjusting the cable. Still, I think pulling and cleaning is the best way to start. ID it, the governor, the speedo drive gear and determine what adapter and gear is going to be correct for you application.
|