Quote:
Originally Posted by DoubleL
Okay the first one is one of the wires looks like only one of the two coming through the floorboard were used? (sorry I think the pic is upside down) The second pic is my floor shifter. It has two wires that were spliced into my ignition. I am thinking this is a safety switch so i can't start in gear. Is this the best way to wire this?
|
That single wire coming off the trans needs to be connected to some sort of trans soleniod (lock up) control.
Painless wiring,Ron Francis, and several others, even Jeg's and Summit, I believe, sell kits for non computer controlled engines using a 700R4. You cannot simply connect to 12V power. Without it, you will not have final lockup of the trans. Also, VERY critical- you HAVE to connect the throttle valve cable to the carb. It IS NOT a detent or kickdown cable. If not connected and adjusted properly, you will destroy the trans. Maybe this is already done, you hadn't mentioned if it was or not.
To answer your other ?? yes connect the two wires from your shifter, to the purple wires of your harness(after removing the jumper. That should give you a neutral safety.