|
Re: Need help!!!
His is run as the latter. The cap rotor ign module coil plugs wires are all new in the last 2 months. And all but plugs and wires are new again since it quit at the gas station. Then it started and ran fine for a couple minutes. Then shut off started fine. And then 10 minutes later it won't start again. Sorry for jumping in. To clear confusion Joe and I are brothers. Hes currently stationed in Washington state and Im I. Wisconsin. we been trying to do this over the phone. Right now I'm guessing the distributor may be bad. The thought of a jumped timing chain crossed my mind but the motors appears to have been rebuilt recently. And since it was running after a new cap and rotor, which the old new ones were burned up, I'd assume timing chain is fine. As far as actual timing goes its set to 14 initial.
Posted via Mobile Device
|