[68LSS1]

Crossmember 56
caliper, rotor, pads and spindle 40 x2
upper A-arms 5 x2
lower A-arms 6 x2
complete coilovers 8 x2
rack & pinion (w/all tie rods) 15

The A-arms were weighed with all bolts, bushings, washers or nuts (including ball joints). The spindles were complete, ready to bolt on and included bearings, pads, rotors, calipers, dust cap/nut and adapters. The coilovers were shocks and springs and mounting hardware. In fact only hardware not weighed was bolts/washers/nuts to install crossmember. SCOTI had 260lbs without calipers/pads or shocks to the 189lbs of the Fatman set up.
If anybody has some A-arms, crossmember, or a power steering gearbox off a '67-72 I'd appreciate if it could be weighed. I'd weigh my old stuff but Ed @ MOTHERTRUCKERS has it.