The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

Roush · 12-27-2013, 02:50 PM

I have done the column auto shift to floor shift (auto trans) swap. Spent many hours of research before making a decision. Bought a used column (non-tilt) off of a board member from the classified section. Needed a new bearing and turn signal switch but other than that it worked well. Had a tough time in the reassembly so take pics of the disassembly process if you go that route.

Ididit and Flaming River have the best member reviews (be careful of knockoffs as stated above by WIDESIDE72, there is some excellent reading provided in this forum on "other" brands). I will probably go this route for a tilt option in a few years.

12-27-2013, 02:50 PM	#8
Roush Registered User Join Date: Jul 2012 Location: SoCal Posts: 24	Re: Steering column. & pedal assembly I have done the column auto shift to floor shift (auto trans) swap. Spent many hours of research before making a decision. Bought a used column (non-tilt) off of a board member from the classified section. Needed a new bearing and turn signal switch but other than that it worked well. Had a tough time in the reassembly so take pics of the disassembly process if you go that route. Ididit and Flaming River have the best member reviews (be careful of knockoffs as stated above by WIDESIDE72, there is some excellent reading provided in this forum on "other" brands). I will probably go this route for a tilt option in a few years.