The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

'68 Newtricks · 02-13-2014, 08:33 PM

Even 5/8" would probably be awesome. The more the caster the better, to a point of course.

Finally got through to CPP. The guy (who I've been working with the whole time) says the arms are designed to work with factory stuff and factory dimensions, so no... the arms change nothing.

I'm probably going to replace the indexing pin on the frame for now (the spacer, not the pin) and run the arms as is. Later, it will be easier to make the change. I'm sure I'll notice a difference if stock is only 1*. The slightly more centered wheel is a bonus.

02-13-2014, 08:33 PM	#15
'68 Newtricks Registered User Join Date: Feb 2014 Location: Los Angeles area :( Posts: 499	Re: Question about the caster mod. Even 5/8" would probably be awesome. The more the caster the better, to a point of course. Finally got through to CPP. The guy (who I've been working with the whole time) says the arms are designed to work with factory stuff and factory dimensions, so no... the arms change nothing. I'm probably going to replace the indexing pin on the frame for now (the spacer, not the pin) and run the arms as is. Later, it will be easier to make the change. I'm sure I'll notice a difference if stock is only 1*. The slightly more centered wheel is a bonus.