|
Re: Welding plates to trailing arms
I used the CPP plates and welded about 1" welds alternating sides to reduce heat and warping.
sorry for the bad pic but you can see the stich welds. I felt welding the plates fully would have been a real waste of time.
After cost of the plates and shipping, blasting, finishing the welds, POR 15, new bushings, and my time I was getting real close to justify new tubular arms.
If I were to do I again, I would cut my own and go from there or buy new aftermarket ones.
Last edited by Voodoo_Child; 11-20-2014 at 12:08 PM.
Reason: forgot pic
|