[Dieselwrencher]

I hope everyone had a great Thanksgiving! I spent some time re-sizing pics while the wife was out Black Friday shopping last night. A few weeks ago I decided I needed to get this truck to drive again. I've been working at it, but other things keep detouring it. I got the new to it trans cleaned and repainted. I installed my double deep trans pan and installed a port for the temp probe. I had to clean up my Goerend torque converter as it surface rusted from sitting in the box for so long. I installed a new SFI rated flex plate, then bolted the trans in. I also built a new trans mount, resealed and replaced a couple of bearings in the NP205, and got it in.








NP205 before



After





Adapting tcase shifter bracket to RH trans



Trans and Tcase installed





New rear driveshaft done. I need to install it.



I still have to bolt the TC in, make a top bracket for my Lokar trans dipstick, hook up the shift linkage, hook up the TV lever stuff, modify the tcase shift handle, wire the trans and tcase sensor. I'm making a new bracket for my pedal to hydra boost push rod, and need to put the fire wall insulation on and new fuse block on before I put the brake pedal assy in for the last time. Plenty to do.

I shopped around for seat belts and finally pulled the trigger on some from Wesco. Thanks Jud, Vintage Windmills, for the heads up on them in his last build thread.