|
Re: Newbie needs advice
In my humble opinion flux throws off too much heat for sheet metal. Lots of holes burned through the panels 
Elf has a really good point - when you cut out the rockers or any other major load bearing section of a truck make sure you tack in some square tube or angle bracket before cutting to make sure your cab doesn't flex and screw up the door gaps.
__________________
'71 Chevy C10, 250 straight six, 3 on the floor, long bed
'70 Plymouth Duster, 340 small block, 4 on the floor, 3.55 ratio 8 3/4 rear
"Rust is a major food group."
"Burn 'em if you got 'em."
|