The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

toolboxchev · 02-26-2016, 08:16 PM

I had to do it a few years back. All by myself. It took a little over 4 hours to remove the engine.

I did this by separating it from the transmission. Do not forget to push a rag into the torque converter hole to prevent the fluid from spilling out everywhere. Better yet use a plastic plug sized correctly for the hole.

02-26-2016, 08:16 PM	#12
toolboxchev Registered User Join Date: Jul 2015 Location: 2nd left past the stump on a dirt road. Posts: 2,629	Re: Pulling engine I had to do it a few years back. All by myself. It took a little over 4 hours to remove the engine. I did this by separating it from the transmission. Do not forget to push a rag into the torque converter hole to prevent the fluid from spilling out everywhere. Better yet use a plastic plug sized correctly for the hole.