Quote:
Originally Posted by snipescastle2
Maybe adding a few washers under the motor mount studs(assuming you have the stock motor mounts) that should keep them clear without doing too much "over-Engineering"
Ben
 |
I was thinking about that last night. I don't have a hoist to lift the engine, would I be able to do it with a floor jack without too much trouble? I think shimming the trans would be much simpler, but I'm not positive it would work, hence my question in the first post.
Quote:
Originally Posted by drewbert41
I have these headers without clearance issues. My motor must be in a dif location than yours.
|
I bought them because of all the good reviews on Summit Racing about the clearance. Aside from this one spot, everything else about the fit of the headers is great. Easy access to spark plugs and flange bolts, cleared the frame and starter without any trouble.
I don't know if my motor mounts are stock, but they are as far forward as they can go. Here is a pic of the problem spot.
