View Single Post
Old 08-09-2016, 09:41 PM   #12
LockDoc
The Older Generation


 
LockDoc's Avatar
 
Join Date: Aug 2006
Location: Montezuma, Iowa
Posts: 26,078
Re: Switch Retaining nut & lock washer?

Quote:
Originally Posted by DJ_Baar View Post
Got the wiper motor switch nut & lock washer from you in mail today. THANK YOU THANK YOU THANK YOU.

PS. Where do you recommend getting the correct tool to remove the ignition switch bezel? What I got from Truck Shop is WAY too big. Offset about 1/8 of an inch and their Customer Service said I may have to bend over tool tabs some to fit. Does that make sense?

Thank you again Leon - you are a BIG help!

No problem. Glad they made it OK.

I made a tool for removing the switch bezels out of a piece of thin wall tubing that just fit inside the bezel. I just made cuts in the tubing that matched the notches and bent the little tabs out to fit in them. It works OK if they are not real tight.

If the one you bought is too big I don't know how bending anything is going to help....

LockDoc
__________________
Leon

Locksmith, Specializing In Antique Trucks, Automobiles, & Motorcycles

(My Dually Pickup Project Thread)

http://67-72chevytrucks.com/vboard/s...d.php?t=829820

-
LockDoc is offline   Reply With Quote