|
Re: Lowering help 69 C10
Quote:
Originally Posted by Jay69fleet
Are you sure? The spuds at the bottom of the spindle. Wouldn't it be towards the center if it were a drop spindle? Also the steering arm is straight. Rear hasn't been blocked either. Just want to drop it a few inches till I save up to get the entire PB setup.
|
Your right, I'm mistaken. The spindle would indeed be near the center and not low like the one shown. "My bad" :redface: I personally wouldn't attempt to lower the front without installing drop spindles first.
__________________
Michael of the clan Hill,
"Two Seventy Two's"
71 1-ton Dually 350 4-Speed
71 C/50 Grain Truck, 350 Split-Axle 4-Speed
02 3/4 ton Express
14 Indian Chief Vintage
1952 Ford 8N, "Only Ford Allowed On The Property" 
"Be American, Buy American" 
|