Thread: 47-55.1 Bed Measurement Request
View Single Post
Old 06-27-2018, 01:27 PM   #5
Rabid Anti-Dentite
Registered User
 
Join Date: Mar 2016
Location: Fort Worth, TX
Posts: 58
Re: Bed Measurement Request

I was planning on cutting where the stake post mount is, sliding it back 9 inches and doing new spot welds. The fender would stay in the original location, but now the gaps between the front and rear of the bed sides would be more symmetrical. I am actually using a 4 door 2002 blazer frame, easier to find then the S-10 where I am living now. I did a 54 last year on the reg cab long bed frame and it turned out nice, but I have just always though the bed height and length looked a little off, so I was gonna change it this go around.
Rabid Anti-Dentite is offline   Reply With Quote