Thread: drive shaft
View Single Post
Old 11-05-2018, 06:46 AM   #4
jjzepplin
Registered User
 
jjzepplin's Avatar
 
Join Date: Feb 2012
Location: Ruskin Florida
Posts: 4,595
Re: drive shaft

Mine had 1/4 inch 12 point bolts on the transfer case side and are o mutha to unbolt. I used a small box end wrench of good quality and put one of the front hubs in lock position and the other in unlock as well as the case in neutral to move the shaft by hand. Then when you get you bolt exposed, lock the other hub and unbolt, repeat until you cramp up! haha! If I have to do it again I will swap the front flange to a nut and bolt type and never look back. I thought of this right after I sold a t-case with that flange on it. DOH!
__________________
70 swb 4x4 406sbc 700r4 203/205 d60/14blt locker yadda yadda http://67-72chevytrucks.com/vboard/s...88#post6935688 Yeller
72 Blazer 2wd conversion project "No Daggum Money" http://67-72chevytrucks.com/vboard/s...d.php?t=550804 LS1-T56 3.73 LSD super budget build
Blanco-2014 Sierra SWB https://67-72chevytrucks.com/vboard/...d.php?t=810350
jjzepplin is offline   Reply With Quote