The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - what pulleys for 250 -w- air?

**old51sedan** · 01-02-2019, 01:31 PM

Richard,
Noticed you went from a 250 to a 292. I'm doing the same with my 69 C-10. I believe I can make the PS from the 250 fit the 292 also. I have bought Vintage air complete with a compressor mount for the right side, I'm also looking for a short electronic distributor from a newer vehicle, but don't know the years or vehicles to look at. I'm currently in Florida and have excess to a few old yards. I believe that one may fit under the compressor because of the fact that the 292 is taller. I currently have a electronic module in my diet in the 250 that maybe I could use. Also I believe I need a 3 grove crank pulley. Have you been able to find one, or did you use a bolt on for the crank.

01-02-2019, 01:31 PM	#4
old51sedan Senior Member Join Date: Oct 2015 Location: Williamston, Mi Posts: 906	Re: what pulleys for 250 -w- air? Richard, Noticed you went from a 250 to a 292. I'm doing the same with my 69 C-10. I believe I can make the PS from the 250 fit the 292 also. I have bought Vintage air complete with a compressor mount for the right side, I'm also looking for a short electronic distributor from a newer vehicle, but don't know the years or vehicles to look at. I'm currently in Florida and have excess to a few old yards. I believe that one may fit under the compressor because of the fact that the 292 is taller. I currently have a electronic module in my diet in the 250 that maybe I could use. Also I believe I need a 3 grove crank pulley. Have you been able to find one, or did you use a bolt on for the crank.