The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

**psoucy** · 06-05-2019, 07:29 PM

I just dropped the cab onto my frame and I can’t get the cab mount holes to line up, the valve covers are hitting the fire wall. I have tall valve covers on my small block motor but I wouldn’t think that would be a problem. This is not a new or different cab, it’s the same one that came with the truck which was completely stock. I will say that I had the motor mount frame brackets out, could they be in backwards, I don,t know if that’s even possible. Any ideas.

06-05-2019, 07:29 PM	#1
psoucy Registered User Join Date: Mar 2017 Location: Bristol Posts: 52	Tall valve covers I just dropped the cab onto my frame and I can’t get the cab mount holes to line up, the valve covers are hitting the fire wall. I have tall valve covers on my small block motor but I wouldn’t think that would be a problem. This is not a new or different cab, it’s the same one that came with the truck which was completely stock. I will say that I had the motor mount frame brackets out, could they be in backwards, I don,t know if that’s even possible. Any ideas.