|
Re: Fuse panel
If you have gone to all the trouble of removing your harness and removing all the tape for inspection. You have a ton of work to do on the just the harness to get it ready to install. Now you are talking about replacing the fuse panel too? Going this route is just asking for trouble.
Your wiring is decades old. Do yourself a BIG favor and get a new harness. You'll not regret it.
__________________
1970 GMC 2500
700R Trans, RideTech 4 link rear suspension, air bagged on all four corners, factory upper/lower A-Arms, 2 inch drop spindles.
350 SBC 300hp
Weiand Supercharger
FiTech 30004 EFI
|