Quote:
Originally Posted by CS1972
I replaced my Retrosound Classic digital radio with a “Antique Automobile” AM-FM slide bar radio, new center speaker and also replaced the antenna with telescoping antenna as I did not like the non-factory look (digital and that it covered all the opening) and was getting tired of the mast “springing back and forth” every time I went into/out of the garage.
After searching “Antenna” I found this thread to be the closest to the subject matter / question I have.
Is the antenna I removed factory? …… see pics and information below.
Part #’s on the nut: 3943656 and 181 300
Part #’s on the base: PMG 3979307
Fixed antenna: 31” long from tip of ball to the base of nut
|
Looks right to me
Part #’s on the nut: 3943656 and 181 300
Correct for low crown nut
Part #’s on the base: PMG 3979307
I'll have to check, but your base looks right
Fixed antenna: 31” long from tip of ball to the base of nut
Couldn’t tell you
The chrome bezel should be stamped 3898672.
The ground “bezel” on that body slips off right? It’s part number 3898673, might be stamped.