Quote:
Originally Posted by vetnat
Thanks old51, yes my question was directed at you, forgot to use the quote function. The headers I have for my 235 do have threaded bungs in them, have not installed yet. A 292 is in the future. I assume for the plate you made, the holes are drilled into an edge? How deep? Thanks again!
|
The plate will not be very big, I drilled the holes close to the edge as possible, then welded a bolt over the hole so it would be on the outside of plate.Not much area under the plate, but all is needed is enough for the hot air to circulate. It might take you a few tries to bend the tubing and get it from headers to the plate, it's a pretty tight space, but should work fine for you.
I done this car about 10-12 years ago, so hard to remember all those little things.