[hugger6933]

I like the H/F 1/8 double ended drill bit. I'll drill out the center then use a step bit to drill out the weld. I also bought a pair of STECK brand spot weld breakers on is flat the other has a 90 degree elbow.I also have a Snap-On brand spot weld cutter it is quite pricey I think I gave like $450 ten or so years ago. But I have done ten spots in less than a minute with it. Of course a die grinder with a cutoff blade if your not trying to save both panels, grind on the waste side till it pops loose. Any tool you use try those steck or similar type spot weld breakers. Look into them I use them a TON. JIM