[Bruce F]

thanks Dashman - yes I used the plastic centering tool that came with the clutch kit .

thanks 72 SB

replace pilot pushing - Done - used brass type one - kit had steel
install flywheel - Done - new bolts torques to 60 ft lbs
install disc using the spline tool that comes with clutch kit (I actually have a 10 tooth input shaft to use) - Done
install PP but push straight in on spline tool so clutch does not "hang" on it to tighten PP bolts) - Done -torqued to 45lb with a dab of blue loctite. - plastic spline tool goes in and out freely.

up next -
Bell housing
clutch fork and TO but not "clipped" on.
Stab trans and bolt in.
push fork on pivot ball
connect fork and clutch pedal linkage
attach shifter
install drive shaft