replace pittman arm and idle arm?? - The 1947 - Present Chevrolet & GMC Truck Message Board Network

aggiedave98 · 04-26-2004, 08:03 PM

I'm putting in a lift kit and plan on replacing the following:

ball joints
tie rod ends

should I also replace the idler arm and pittman arm while I'm in there?? It's only about an extra $70-$80 for both. I don't want to replace if it makes no sense, but since I'm in there it would be easy to.

btw, it's on an '89 suburban 2wd with 115k miles on it.

68step · 04-27-2004, 01:08 AM

Ya I would replace them but the pitman arm is a PITA you have to unbolt the steering box and swivil it back to get a puller on it.

**COBALT** · 04-29-2004, 05:08 PM

???

I was able to yank my pitman pretty easy on my truck, but of course it's a '69. A Puller and patience is all that was required.

To answer your question I would replace them. Both have greasable joints just like your tie rods and ball joints. Might as well start off with a good steering system.

04-26-2004, 08:03 PM	#1
aggiedave98 Senior Member Join Date: Aug 2003 Location: Sugar Land, TX Posts: 1,007	replace pittman arm and idle arm?? I'm putting in a lift kit and plan on replacing the following: ball joints tie rod ends should I also replace the idler arm and pittman arm while I'm in there?? It's only about an extra $70-$80 for both. I don't want to replace if it makes no sense, but since I'm in there it would be easy to. btw, it's on an '89 suburban 2wd with 115k miles on it.

04-27-2004, 01:08 AM	#2
68step Registered User Join Date: Mar 2004 Location: Nor kal Posts: 59	Ya I would replace them but the pitman arm is a PITA you have to unbolt the steering box and swivil it back to get a puller on it. __________________ 95 sfa 38.5 swamper TBI vortech 68 chevy stepside

04-29-2004, 05:08 PM	#3
COBALT Senior Member Join Date: Sep 2001 Location: Seattle, WA, USA Posts: 5,817	??? I was able to yank my pitman pretty easy on my truck, but of course it's a '69. A Puller and patience is all that was required. To answer your question I would replace them. Both have greasable joints just like your tie rods and ball joints. Might as well start off with a good steering system. __________________ '69 3/4 ton C20 2wd-350ci/TH400 '69 3/4 ton Custom 20 2wd-350ci/4sp Manual '99 2wd 5.7 Chevy Tahoe Seattle, WA.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.