Cab Light Lense - The 1947 - Present Chevrolet & GMC Truck Message Board Network

**uncle** · 11-16-2004, 07:11 PM

Can you still buy the factory cab light lenses. I found a # on 1. It is Signal Stat 9069 or 6906. Thanks Tim.

**Ironhorse** · 11-16-2004, 07:41 PM

If you are referring to the behind the head above ya' cab light they are being reproduced. Several vendors offer them, not sure of the price. From time to time I see them offered on eBay, supposed as NOS GM parts, again not sure what they bring price wise. After a few years the heat from the bulb and just age sure makem' brittle ! Pull it out and falls apart in your hands.

ken betz · 11-16-2004, 07:48 PM

He is looking for the lenses that go on the "Factory" cab lights
They were an option only on 3/4 and larger trucks
Just try'n to help!

**Ironhorse** · 11-16-2004, 08:07 PM

My Bad

Longhorn Man · 11-16-2004, 09:29 PM

They were avalible on all trucks...not just 3/4 and up.
I'd bet they are still avalible at the dealer. They were on the larger trucks well into the 70's, and I think even into the 80's.

GROUCH · 11-16-2004, 09:53 PM

They Are Availible At The Dealer Here In Abilene Tx. They Said They Were Used Up To About 78 Or So. I Have A 70 Cst 1/2 Ton Cab For Sale That Has Factory Cab Lights.

**uncle** · 11-16-2004, 10:03 PM

Do you know if the smaller # on the lense is the part# or if you have the # I would sure appreciate it.

GROUCH · 11-16-2004, 10:07 PM

I Just Went To The Dealer And Asked For What I Needed And They Looked It Up In The Old Books. I Think They Ran About $9.00 Each.

**uncle** · 11-16-2004, 10:10 PM

Mine have been replaced recently, but one is cracked and I don't need a place for rust to start. I'll try the smaller # on the lense to see if it's a good GM#. Thanks Fellers.

**PICKMUP** · 11-16-2004, 10:06 PM

The ones you get from the dealer are the later model style. They may even look better than the original "hockey puck" style, but they are not the same ones that came on our trucks.

1969 GMC · 11-16-2004, 10:08 PM

I am not sure what year it was they stopped using the hockey puck style and started using the torpedo shaped ones, I think it was 71. Anyway, the newer torpedo ones will bolt right on up and look better IMO if you dont care that much about originality. The newer style are dime a dozen in the junkyards, I got a set of 5 that looked brand new off of an 80's C20 for $9 and they look great on my truck. They used them on 1/2 and 3/4 ton trucks til '87, and 1 tons and suburbans until '91, and also used them on the bigger trucks too (not sure of what years).

Robert1970C20rstbukt · 11-16-2004, 11:22 PM

I picked up about 12 of those at the junkyard for $2, most are faded but they're good for what I need 'em for. You can get those assemblies new at Napa is what I was told.

dwaite72lnghrn · 11-16-2004, 11:23 PM

The '72 can use NAPA part 680-2488. That is just the lens, They also have the rubber and lens as an assembly.

Castiron9 · 11-17-2004, 12:53 AM

If your talking about this style,I got mine at NAPA.I think they were about 9.00 buckts for each set.............

A few 72's · 11-17-2004, 09:41 AM

Uncle this may help, copied from a post I did in sept for the h-puck ones.

Quote:

Originally Posted by A few 72's

Not mine, just seen on e-bay 3 hours left. Know a few were looking for these.

Have 3, part #5961757 NOS (new old stock) Just foud in Storage. No Reserve.

http://cgi.ebay.com/ebaymotors/ws/eB...tem=7921986846

A few 72's · 12-21-2004, 12:06 PM

Uncle, Not sure if you found them but, here's one more part number that I seen on ebay.

"67-72 CHEVY GMC CLERANCE LIGHTS THAT MOUNT ON CAB BRAND NEW STILL IN BOX GM PART NUMBER IS 36-4480"

Here is the link
http://cgi.ebay.com/ebaymotors/ws/eB...category=39405

junkyardjohn · 12-21-2004, 01:15 PM

THE LENSES ARE AVAILABLE FROM CAR-QUEST OR NAPA AUTO PARTS STORES FOR AROUND $2.00 EACH.

JOHN

**uncle** · 12-21-2004, 08:33 PM

Yes, I bought a few at the dealer, but not as cheap as John. I'll have to check at NAPA. Thanks Tim.

11-16-2004, 07:11 PM	#1
uncle Senior Member Join Date: Aug 2003 Location: Conyers,Ga. Posts: 7,288	Cab Light Lense Can you still buy the factory cab light lenses. I found a # on 1. It is Signal Stat 9069 or 6906. Thanks Tim.

11-16-2004, 07:41 PM	#2
Ironhorse Senior Member Join Date: Jul 2001 Location: Wellington, Ks Posts: 10,301	If you are referring to the behind the head above ya' cab light they are being reproduced. Several vendors offer them, not sure of the price. From time to time I see them offered on eBay, supposed as NOS GM parts, again not sure what they bring price wise. After a few years the heat from the bulb and just age sure makem' brittle ! Pull it out and falls apart in your hands. __________________ 1971 Chevy 1/2T 4x4 LWB 350 V-8 Was sm465-now 350TH/np205 Tilt, Tach, Towhooks Original Truck AM/FM Wellington, Ks

11-16-2004, 07:48 PM	#3
ken betz AKA willie127 Join Date: Jul 2004 Location: Lake City, GA Posts: 72	light lenses He is looking for the lenses that go on the "Factory" cab lights They were an option only on 3/4 and larger trucks Just try'n to help!

11-16-2004, 08:07 PM	#4
Ironhorse Senior Member Join Date: Jul 2001 Location: Wellington, Ks Posts: 10,301	My Bad __________________ 1971 Chevy 1/2T 4x4 LWB 350 V-8 Was sm465-now 350TH/np205 Tilt, Tach, Towhooks Original Truck AM/FM Wellington, Ks

11-16-2004, 09:53 PM	#6
GROUCH Registered User Join Date: Aug 2004 Location: Abilene Tx Posts: 39	Cab Lenses They Are Availible At The Dealer Here In Abilene Tx. They Said They Were Used Up To About 78 Or So. I Have A 70 Cst 1/2 Ton Cab For Sale That Has Factory Cab Lights.

11-16-2004, 09:29 PM	#5
Longhorn Man its all about the +6 inches Join Date: Jan 2001 Location: Hilliard Ohio Posts: 2,690	They were avalible on all trucks...not just 3/4 and up. I'd bet they are still avalible at the dealer. They were on the larger trucks well into the 70's, and I think even into the 80's.

11-16-2004, 10:03 PM	#7
uncle Senior Member Join Date: Aug 2003 Location: Conyers,Ga. Posts: 7,288	Lenses Do you know if the smaller # on the lense is the part# or if you have the # I would sure appreciate it.

11-16-2004, 10:07 PM	#8
GROUCH Registered User Join Date: Aug 2004 Location: Abilene Tx Posts: 39	Cab Lenses I Just Went To The Dealer And Asked For What I Needed And They Looked It Up In The Old Books. I Think They Ran About $9.00 Each.

11-16-2004, 10:10 PM	#9
uncle Senior Member Join Date: Aug 2003 Location: Conyers,Ga. Posts: 7,288	Lense Mine have been replaced recently, but one is cracked and I don't need a place for rust to start. I'll try the smaller # on the lense to see if it's a good GM#. Thanks Fellers.

11-16-2004, 10:06 PM	#10
PICKMUP "Trucks with Class" Join Date: Jul 2000 Location: OLYMPIA, WA, USA Posts: 8,159	The ones you get from the dealer are the later model style. They may even look better than the original "hockey puck" style, but they are not the same ones that came on our trucks. __________________ Email: frankeham@comcast.net Phone: 360-956-7170

11-16-2004, 10:08 PM	#11
1969 GMC Registered User Join Date: Feb 2003 Location: The Rubber City Posts: 5,498	I am not sure what year it was they stopped using the hockey puck style and started using the torpedo shaped ones, I think it was 71. Anyway, the newer torpedo ones will bolt right on up and look better IMO if you dont care that much about originality. The newer style are dime a dozen in the junkyards, I got a set of 5 that looked brand new off of an 80's C20 for $9 and they look great on my truck. They used them on 1/2 and 3/4 ton trucks til '87, and 1 tons and suburbans until '91, and also used them on the bigger trucks too (not sure of what years). __________________ 1969 GMC K2500 1996 Honda Accord 2007 Kawasaki KLR 650

11-16-2004, 11:22 PM	#12
Robert1970C20rstbukt Registered User Join Date: Jun 2004 Location: Beeville, Texas Posts: 1,943	I picked up about 12 of those at the junkyard for $2, most are faded but they're good for what I need 'em for. You can get those assemblies new at Napa is what I was told. __________________ RJD 1984 Chevrolet C30 welding truck 454/SM465 1977 GMC C15 pickup 350/TH350 1970 Chevrolet C20 pickup 350/TH400 1970 Chevrolet K20 Suburban 454/TH350 1969 GMC 8500 478M V6/5 spd winch truck

11-16-2004, 11:23 PM	#13
dwaite72lnghrn Registered User Join Date: Jun 2002 Location: central pa Posts: 1,525	The '72 can use NAPA part 680-2488. That is just the lens, They also have the rubber and lens as an assembly. __________________ 72 longhorn c30 502BB/th400/fact air/4.11rear/ custom camper 72 bug(the better half's) under reconstruction 2009 HHR aqua blue 71 GMC k20 350/sm465 2009 Chevy hd3500 6.6 Victory Red crew cab dually Dave & Jeanne

11-17-2004, 12:53 AM	#14
Castiron9 72 LONGHORN OWNER Join Date: Sep 2002 Location: Seattle Wash. Posts: 963	If your talking about this style,I got mine at NAPA.I think they were about 9.00 buckts for each set............. Attached Images __________________ 72-SUPER CHEYENNE/20 LONGHORN 70-C/30 DUALLY

12-21-2004, 12:06 PM	#16
A few 72's Registered User Join Date: Mar 2004 Location: Alabama Posts: 703	Uncle, Not sure if you found them but, here's one more part number that I seen on ebay. "67-72 CHEVY GMC CLERANCE LIGHTS THAT MOUNT ON CAB BRAND NEW STILL IN BOX GM PART NUMBER IS 36-4480" Here is the link http://cgi.ebay.com/ebaymotors/ws/eB...category=39405 __________________ 1972 C10 SWB 350 / T400 1972 SWB GMC 350/T350 1972 Cheyenne 20 super "long horn". 402BB / T400 1972 Suburban C10 Deluxe 350 / T350 and a few more.. http://www.myspace.com/afew72s



Register or Log In To remove these advertisements.

12-21-2004, 01:15 PM	#17
junkyardjohn Registered User Join Date: Aug 2001 Location: SOMERSET KY. Posts: 6,425	THE LENSES ARE AVAILABLE FROM CAR-QUEST OR NAPA AUTO PARTS STORES FOR AROUND $2.00 EACH. JOHN __________________ junkyardjohn 69 1 TON TOW TRUCK // 84 4WD CUCV BLAZER// 85 1 TON 4WD STAKE TRUCK// 86 M1031 5/4 TON 4WD CUCV// ALOT OF OLD TRUCKS FOR ONE OLD MAN TO DRIVE. THERES ROOM FOR ALL OF GODS CREATURES RIGHT NEXT TO MY MASHED POTATOES// LIFE MEMBER OF P.E.T.A (PEOPLE EATING TASTY ANIMALS) DON'T RENT U-HAUL ALWAYS TELL THE TRUTH IT WILL AMAZE PART OF THE PEOPLE & ASTONISH THE REST

12-21-2004, 08:33 PM	#18
uncle Senior Member Join Date: Aug 2003 Location: Conyers,Ga. Posts: 7,288	Lenses Yes, I bought a few at the dealer, but not as cheap as John. I'll have to check at NAPA. Thanks Tim.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

Register or Log In To remove these advertisements.