98 z71 differential problems - The 1947 - Present Chevrolet & GMC Truck Message Board Network

jamal · 07-11-2005, 01:16 AM

I have a 98 z71 and when I grab the driver side axle and shake it I can see the axle that slides into the differential move up and down. The haynes manual says I need to take it to a dealership b/c it requires a special tool. Anyone ever replaced this bearing? If so how hard is it, how do I do it, how much will this cost me, and are there any special tools I need?

**kwmech** · 07-11-2005, 01:19 AM

Bearing puller or what I use is a slide hammer with an attachment just for the semi float bearings.

jamal · 07-11-2005, 01:28 AM

sounds simple, I will try this, thanks a lot.

07-11-2005, 01:16 AM	#1
jamal Registered User Join Date: Apr 2005 Location: Bridgeport, AL Posts: 363	98 z71 differential problems I have a 98 z71 and when I grab the driver side axle and shake it I can see the axle that slides into the differential move up and down. The haynes manual says I need to take it to a dealership b/c it requires a special tool. Anyone ever replaced this bearing? If so how hard is it, how do I do it, how much will this cost me, and are there any special tools I need? __________________ 67 chevy stepside, 6 cylinder, three on the tree, small window. Currently in resto.

07-11-2005, 01:28 AM	#3
jamal Registered User Join Date: Apr 2005 Location: Bridgeport, AL Posts: 363	sounds simple, I will try this, thanks a lot. __________________ 67 chevy stepside, 6 cylinder, three on the tree, small window. Currently in resto.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

07-11-2005, 01:19 AM	#2
kwmech Senior Member Join Date: Mar 2003 Location: Colfax-California Posts: 8,689	Bearing puller or what I use is a slide hammer with an attachment just for the semi float bearings.



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.