|
|
|
09-07-2010, 05:15 PM
|
#1 |
|
Registered User
Join Date: Jul 2010
Location: kapaa kauai
Posts: 19
|
Turn signal help
Have a 1962 fleet side and was wondering where the turn signal wiring block is suppose to be located. Mine is obviously under the dash on the steering column,but is it suppose to be on top of the column or below it. I see no screw holes anywhere on my lower column. If you have a 1960-1962 this should make some sense,I hope. Thanks for any info
Posted via Mobile Device |
|
|
|
09-08-2010, 12:56 PM
|
#2 |
|
Registered User
Join Date: Jan 2002
Location: cornville, maine
Posts: 659
|
Re: Turn signal help
I'm replacing mine now too. Mine attaches to the lower right side of the column. The screws are off set. Held on by two screws.
__________________
jku Cornville, Maine 68 C10 burb 42 Willys MB 46 Dodge WF-32 1.5 ton 53 & 56 Olds' 60 Cadillac 22 Dodge Brothers |
|
|
|
|
09-08-2010, 06:13 PM
|
#3 |
|
Registered User
Join Date: Jul 2010
Location: kapaa kauai
Posts: 19
|
Re: Turn signal help
Thanks for the info, do you know how the steel wire attaches to the turn signal switch? Mine fell off .
Posted via Mobile Device |
|
|
|
|
09-09-2010, 08:15 AM
|
#4 |
|
Registered User
Join Date: Jan 2002
Location: cornville, maine
Posts: 659
|
Re: Turn signal help
The wire clips into the switch. My new switch is different than the original, but the new one still clips in.
__________________
jku Cornville, Maine 68 C10 burb 42 Willys MB 46 Dodge WF-32 1.5 ton 53 & 56 Olds' 60 Cadillac 22 Dodge Brothers |
|
|
|
 |
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
