3970024

[BIGPIMP]

got this engine out of a running truck ,runs good .i think i'll put new stock cam ,hv oil pump ,350 heads and 4bl carb intake . question is i think it has what they call 202 heads and they don't have holes drilled for a/c comp etc. .guys what heads and intake should i look for .o yeah it's a 307 engine .

[BIGPIMP]

i'm looking for the intake with the oil filler tube coming thru the intake .what year was that ?

[raycow]

Originally Posted by BIGPIMP

i'm looking for the intake with the oil filler tube coming thru the intake .what year was that ?

I believe the last year for the oil fill pipe was 67 or 68. Any intake older than that should have it. The manifold on my 60 has the pipe.

Ray

[bama63]

due to the small bore (3-7/8) i would go with a set of 305 heads to keep the compression up and if you look for a set of HO heads they can be had with large valves and improved ports and as far as the intake goes look for an old torker-2 or 69 or older gm intake hope this helps

[bama63]

try here http://www.thedirtforum.com/castings.htm if its the same engine as in your flicker folder it is a 3970014 which is a 68 - 79 350 200-255 2&4-Bolt main and the heads are positively double hump heads by the pics and are most likely cast number 3890462 62-68 1.94/1.50 & 2.02/1.6 250-350 64 CC Chambers No bolt holes, double humps hope this helps

[Captainfab]

I agree

Those heads were available with either 2.02 or 1.94 intake valves. More that likely those have 1.94 intake valves. There are better heads than those, but it depends on what you expect from this engine and what your budget is. If it runs as it is, I would just leave the heads on there.

Originally Posted by bama63

try here http://www.thedirtforum.com/castings.htm if its the same engine as in your flicker folder it is a 3970014 which is a 68 - 79 350 200-255 2&4-Bolt main and the heads are positively double hump heads by the pics and are most likely cast number 3890462 62-68 1.94/1.50 & 2.02/1.6 250-350 64 CC Chambers No bolt holes, double humps hope this helps

[BIGPIMP]

Originally Posted by bama63

try here http://www.thedirtforum.com/castings.htm if its the same engine as in your flicker folder it is a 3970014 which is a 68 - 79 350 200-255 2&4-Bolt main and the heads are positively double hump heads by the pics and are most likely cast number 3890462 62-68 1.94/1.50 & 2.02/1.6 250-350 64 CC Chambers No bolt holes, double humps hope this helps

it's a diff engine than in my sig

[mikie 1954]

If you look in summit racing and jegs catalog they have edelbrock manifolds with the oil fill tubes,may be others available.