Need pictures of where my A/C hoses go

[Gordonr1973]

Hi, looking to use the docsblocks extensions listed from Glock's Fred build on my compressor in the stock position on a 2004 6.0L motor....

Need to see some good pictures of what frame mods people did or how they ran their lines.

Would also like comments and pictures of what lines and hoses to where?

Feel free to draw arrows on my pics if it helps...I have been searching the forum and net today without much luck on finding instructions.

Thanks in advance!!

[clinebarger]

The black arrow is the Suction side (Low side) hooks the the accumulator.
The yellow arrow is the Discharge side (high side) hooks to the condenser.
The white line is where you will have to notch, take as little of the frame that you can.

Couldnt get good pics, Its dark.

[HavinSomeFun]

I forgot to get the pics for you. However, the pictures above are correct. I used the factory hoses from 6.0 and had the ends changed to match my older system. I spent about $90 for all of it. The hose place was able to un-solder the 6.0 ends and turn them the way I needed them... Looks factory!

[paul mora]

I am doing the same conversion, what headers are you using?
Posted via Mobile Device

[Gordonr1973]

Originally Posted by paul mora

I am doing the same conversion, what headers are you using?
Posted via Mobile Device

Speed & Performance

[Gordonr1973]

Cline & Having some fun: thanks for the good info, I will get some hoses made up and post pics in my build thread!

Thanks again!!