need a pic of exhaust manifold

[hilljob26]

i am needing to change my exhaust manifolds from the factory truck ones to something smaller, like maybe the trailblazer ones,,does anyone have a pic of the trailblazer ones with measurements so i can see if they will fit,my motor might be sitting just a hair low in the frameand i need to see if i need to raise it up, or if those will work,,mainly need how tall, how widefrom the flange.thanx

[mrhurt73]

here is a whole thread just for trailblazer manifolds
http://67-72chevytrucks.com/vboard/s...d.php?t=530623

if this doesnt get you what you want let me know and i can measure any specifics for ya.

[BR3W CITY]

I don't have measurements, but here are some shots I have of the TBSS manifolds, off and on my 66/lq4.

[JJH Jimmy]

They will fit. I have been following your build and I know that you are using the AA adapter. I am doing the same thing and I kept my TC in the stock position and my engine is at 5 degrees. The flange on the passenger side is close to the frame rail but they fit with no trimming. I will try to post some pictures tomorrow.

[hilljob26]

i agree, and after looking at the pics im sure they will,,and to buy them for 125 shipped is a killer deal right now since just the right side is going for that on ebay

[mcmlxix]

I have a set of 2010 Camaro manifolds on my K5...

2010 Camaro manifold... Camaro on the left, Sierra on the right...



Its 7" from the last manifold bolt on the head straight down to the flat gasket surface of the flange.
It sticks out 5.25" from the side of the block at its widest point. (Opposte of where the starter would attach.)

[JJH Jimmy]

Here are the pictures. I got my TB SS manifolds and heat shields from GM parts Direct for about $180.00 to my door.

[hilljob26]

Originally Posted by JJH Jimmy

Here are the pictures. I got my TB SS manifolds and heat shields from GM parts Direct for about $180.00 to my door.

nice....you should really have a build thread, i would like to see more of your project

[JMac11]

JJH JImmy.... great looking exhaust.... Where did you get the flanges for the Tbss manifolds???

[JJH Jimmy]

Originally Posted by JMac11

JJH JImmy.... great looking exhaust.... Where did you get the flanges for the Tbss manifolds???

When i got my engine it came with the truck manifolds with the flanges and the chunk of pipe with the o2 bungs. I cut them off and welded them to the stainless tubing using 309 wire.

[JJH Jimmy]

Originally Posted by hilljob26

nice....you should really have a build thread, i would like to see more of your project

I know. I have been meaning to for some time. I just need to spend an afternoon on the computer instead of in the barn!

[JMac11]

Great.... how close is the right side, lloks close but may be the camera angle

[Hart_Rod]

I've got a set of exhaust manifolds off a 2013 Camaro SS with only 135 miles. If they will work for you, shoot me a PM.