|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
|
|
03-23-2013, 07:48 PM
|
#1 |
|
Registered User
Join Date: Dec 2012
Location: winchester, va
Posts: 17
|
steering arm install help lol
i have a 87 3/4 i actually got the arm off quite easy to with a ball point hammer
 any ways i got new nuts and cone washers. how do u get them to get flush with the new sterring arm for the lift. or do they stick out like mine about 1/4 inch or so. there tight but truck is on a jack stand so dont wanna yank too too hard. any help would be great thanks
|
|
|
|
03-23-2013, 08:30 PM
|
#2 | |
|
just can't cover up my redneck
Join Date: May 2004
Location: Columbus OH
Posts: 11,414
|
Re: steering arm install help lol
They may stick up a little. It depends upon how deep the tapered holes were drilled in the new arm. I have seen them like that, though a 1/4" sounds excessive...
__________________
You can review the site's rules here. Quote:
Bad planning on your part does not necessarily constitute an instant emergency on my part.... The great thing about being a pessimist is that you are either pleasantly surprised or right. 
|
|
|
|
|
|
03-23-2013, 09:32 PM
|
#3 | |
|
Registered User
Join Date: Dec 2012
Location: winchester, va
Posts: 17
|
Re: steering arm install help lol
Quote:
Posted via Mobile Device |
|
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
