How to attach the inner fender dust sheilds

[jbgroby]

I was able to pick up a set of OEM inner fender braces and new dust shield rubber from Tony at 4-5-6 chevy (Thank You) Does any one have an explaination on how to attach them of a guideline on placement?

Is it as simple as stripping some copper wire and making staples?

[Clyde65]

Yep! That's exactly what I did. I clamped them together drilled small holes and ran the wire.
Posted via Mobile Device

[65chevysub]

I made staples out of some small wire several years ago. I made a radiator seal for my 65 out of some material I had purchased and used the original holes. It looks factory. Good Luck.

[jbgroby]

Anybody got a pic I'm trying to get them to set right?

[rossboss]

I just used staples out of my staple gun. I held the piece of rubber in place and drilled holes in the rubber using the existing holes in the metal piece as a guide. The staples fit perfect, just shoved them through the rubber and bent them over.

[jbgroby]

Originally Posted by rossboss

I just used staples out of my staple gun. I held the piece of rubber in place and drilled holes in the rubber using the existing holes in the metal piece as a guide. The staples fit perfect, just shoved them through the rubber and bent them over.

Thanks for the picture, that helps me a lot (worht a thousand words) will use copper wire, AND some adheavsive - I likes lots of protection

[cru_zn_29]

Stainless paper clips has worked for me. You can reshape to fit old holes.
kenny

[63burban]

I have stainless staples here just for that purpose, I use a hammer and dolly to bend them over after drilling the holes.

[par4tom]

I used a rivet gun. Drilled some holes through the molding and sheet metal, put some RTV adhesive on both the panel and molding, stuck them together and used a rivet.

[slorio]

Jake:
I used floral pins. I have a picture of them here:

http://67-72chevytrucks.com/vboard/s...57#post4310757

Hope this helps.
Regards,
Steve
New Orleans

[jbgroby]

hey thanks steve, this way I don't need bend much!

Jake

[64tantruck]

Hi all. the corvairs "tins" ave the same type of staple to hold the rubbers. You can but the stainless steel wire from Clarks Corvair also.

Glenn

[61K10]

ok--now that the seals are on what is used to mount them back on the fenders? the stock inserts are gone. pop rivet or self tapers?

[jbgroby]

456chevy has the clips, they came with my package.

[61K10]

thanks jb--i bought some from somebody and they were too small. will ck out 456--