My full exhaust the hard way

[blazer2007]

Got tired of the noise of short exhaust and finally one got torn off by a curb ,so I knew I had to do some rust repair on the floor and after digging through the rust I decided to replace the whole floor[,how hard could that be] a new floor was too much money .Got the floor torn out and decided to do the exhaust.Got some pipe bent the way I thought it should be and welded them together,just have to put on the turnouts and done.

[blazer2007]

I used .063 1 in. sq. tubing and using 14 gauge for the floor.Now I have to try and make some wheel tubs

[blazer2007]

I still have to put in a couple more cross braces

[68Timber]

How far up did you move the floor?

[blazer2007]

Originally Posted by BRUISER

How far up did you move the floor?

It,s up 2 inchs

[dragonball98312]

This is what I plan to do when I bag my blazer. Looking good!

[dragonball98312]

Also is that bench using some sort of stock mounting hardware or homemade?

[blazer2007]

Originally Posted by dragonball98312

Also is that bench using some sort of stock mounting hardware or homemade?

I,m using a bench seat,I didn,t want the rear seat but wanted room for 3 if needed.I made the brackets for it,was quite easy.I like the old look ,didn,t want any fancy buckets or bench seats

[blazer2007]

Here is a pic of the seat,I,ll be getting rid of the auto meters and use stock dash and column shift