|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
|
|
10-26-2014, 02:43 PM
|
#1 |
|
Registered User
 Join Date: Jan 2011
Location: Pittsburgh
Posts: 69
|
Lower Ball Joint Seal Issue
I have the lower ball joint installed and am trying to get the seal installed. I got the seal over the lip of the ball joint but I can't get it to go all the way down to touch the lower arm surface. You can see in the second picture how far over tge like the seal.is. Based on the picture is the seal seated completely? If not is there a trick to getting it the rest of the way? Lastly this is a 72 c10
 
|
|
|
|
10-26-2014, 09:47 PM
|
#2 |
|
Senior Member
Join Date: Apr 2000
Location: Delta,Pa
Posts: 14,948
|
Re: Lower Ball Joint Seal Issue
They suck to get in place. I usually shave the inside of the boot slightly with a razor and use two pair of channel locks to get them to slide into the place. There is a metal ring inside the rubber that locks it in place.
__________________
Owner of North Point Car Care in Dundalk Md. We specialize in custom exhaust on both modern and classic vehicles. We are a full service auto shop from classics to modern vehicles. Feel free to contact me with questions. I will give a 10% discount to any board member. |
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
