I need some assistance under dash around column

[Chevy3+3]

I pulled my column out and pedal assembly out and now I have 3 things I can't remember where they go. I'm up the creek without a paddle.

1. There's a rubber line (vacuum line?) that I obviously disconnected and can't remember where it went. It had to have been attached to the column or iny way at some point if I pulled it loose. Any ideas where it goes?

2. There is a black 2 wire connector with orange & white wire running to it. I'm assuming it goes to the brake light switch? But I also have a white/clear 2 wire plug with a purple & pink wire also under the dash hanging just right of where column sat.

I need help getting these things back where they belong. Any help is greatly appreciated. First pic shows the rubber hose. 2nd pic shows the pink & purple wired plug and 3rd pic shows the orange & whote wired plug. Thanks

[Wgesnerjr]

I think they all go to the brake light switch. 1 for brake lights, 1 for cruise control/lock up TQ. Rubber line bleeds vaccuum off curise control when brake is applied. Check the column. GM keyed their plugs so assembly line works could not mix them up. Should work in your favor too.

[Chevy3+3]

Well I figured out through wiring diagram that the orange & white wire plug goes to brake light switch. I already have the other plug for cruise control hooked up to brake light switch. So that still leaves me with the 2 wire plug with purple & pink wires. I am so confused because I know I disconnected the plug from somewhere but can't find any place to plug it back in.

As for the rubber line where does it attach? I'm almost sure I pulled it loose from something but can't find it either. Geez! This is frustrating because I usually don't have these kinds of problems when I work on things

[1968vetL-71]

Did ya convert this to a manual trans?
I did this to my old 91 crew cab, I had to clean up po's wiring messes from add ons under dash. time consuming!!

[Chevy3+3]

Originally Posted by 1968vetL-71

Did ya convert this to a manual trans?
I did this to my old 91 crew cab, I had to clean up po's wiring messes from add ons under dash. time consuming!!

I am in the process of converting it to a manual right now. I swapped out the pedal assembly. The problem is I know I unplugged the dang thing but can't find where to plug it back in. Im reinstalling the same column so it must not go to the column itself becasue I can't see any spots left to plug anything into

[Chevy3+3]

Ok I found out where the rubber vac hose ran to. Now I just need to determine where the 2 wire plug goes with the pink & purple wires

[nonstop]

Could it for be a neutral safety switch? Was the truck always an auto?

[Chevy3+3]

Originally Posted by nonstop

Could it for be a neutral safety switch? Was the truck always an auto?

Truck was always an auto. After some info from another member we believe it is for the cruise control. I will check when I get home from work late tonight.