Am I bench bleeding right? - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Isaiah92260 · 03-19-2016, 01:35 AM

I just put these plugs in after I was done so it won't keep leaking. I bench bleed it with these plugs off and got a good flow sometimes, I feel like I have air occasionally, I made sure there was always fluid.. Probably bench bleed it for a hour or more straight while I was watching tv lol.... But I noticed this 67 brake cylinder didn't come with the rubber hose to bleed with, just these two blue plugs.... Does it sound like I didn't every thing right? This it my first time bench bleeding

61_FL_Apache · 03-19-2016, 08:08 AM

Here is a handy video clip on this.

https://www.youtube.com/watch?v=vOTkVAeU_n4

**chevy2tom** · 03-19-2016, 01:24 PM

I picked up a universal kit from napa $8

GRX · 03-22-2016, 03:03 PM

Should not take more than a couple minutes to force all the air out. When pumping, be sure the reservoirs do not go dry. Then you have to start over. Get the kit recommended above.

Even with those plugs you will likely get air in there when installing the lines. Pump to the wheel cylinders until all air is removed.

03-19-2016, 01:35 AM	#1
Isaiah92260 Registered User Join Date: Jul 2015 Location: Whittier, CA Posts: 851	Am I bench bleeding right? I just put these plugs in after I was done so it won't keep leaking. I bench bleed it with these plugs off and got a good flow sometimes, I feel like I have air occasionally, I made sure there was always fluid.. Probably bench bleed it for a hour or more straight while I was watching tv lol.... But I noticed this 67 brake cylinder didn't come with the rubber hose to bleed with, just these two blue plugs.... Does it sound like I didn't every thing right? This it my first time bench bleeding Attached Images

03-19-2016, 08:08 AM	#2
61_FL_Apache Who Me? Join Date: Sep 2010 Location: Royal Palm Beach, FL Posts: 4,067	Re: Am I bench bleeding right? Here is a handy video clip on this. https://www.youtube.com/watch?v=vOTkVAeU_n4 __________________ Steve 1997 Tahoe LT 4D 2WD (DD) 2001 Blazer 4D 2WD 1961 Apache 10 (sold) 1965 C10 Stepper (sold)

03-19-2016, 01:24 PM	#3
chevy2tom Senior Member Join Date: Aug 2009 Location: Wheeling, Illinois Posts: 703	Re: Am I bench bleeding right? I picked up a universal kit from napa $8

03-22-2016, 03:03 PM	#4
GRX Registered User Join Date: Jul 2010 Location: MD Posts: 1,937	Should not take more than a couple minutes to force all the air out. When pumping, be sure the reservoirs do not go dry. Then you have to start over. Get the kit recommended above. Even with those plugs you will likely get air in there when installing the lines. Pump to the wheel cylinders until all air is removed. __________________ 1969 c-10 Step Side Long Bed. I-6 250cid = = 1969 Pontiac GTO hard top. 400, 4-speed.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.