|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
|
|
06-21-2016, 06:19 PM
|
#1 |
|
Registered User
Join Date: Jun 2016
Location: Las vegas
Posts: 12
|
Raised bed. Did I do this right?
Hello all I am new to the forum,
I'm raising my bed floor and was wondering if someone out there can tell me if I'm doing this right before I get any further into it. What I did was measure from the top of the frame rail up to the top of the c-notch and cut that out of the sides of the bed side. I've looked around on the forum and found no pics or tutorial on a bolt together 73-87 bed. Thanks Richy |
|
|
|
06-21-2016, 06:53 PM
|
#2 |
|
Registered User
Join Date: Apr 2001
Location: DALLAS,TX
Posts: 22,068
|
Re: Raised bed. Did I do this right?
There isn't only one way to attack this. There are several 'right' ways....
That method works.
__________________
67SWB-B.B.RetroRod 64SWB-Recycle 89CCDually-Driver/Tow Truck 99CCSWB Driver All Fleetsides @rattlecankustoms in IG Building a small, high rpm engine with the perfect bore, stroke and rod ratio is very impressive. It's like a highly skilled Morrocan sword fighter with a Damascus Steel Scimitar..... Cubic inches is like Indiana Jones with a cheap pistol. |
|
|
|
|
| Bookmarks |
| Tags |
| bed floor, body drop bed, raise bed |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
