|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
|
|
01-06-2018, 07:51 AM
|
#1 |
|
Junior Member
 Join Date: Dec 2017
Location: vader, WA
Posts: 57
|
4l60e to np205 a little easier
Im about to begin my swap using a 6.0/4l60e out of a 2001 yukon denali. Has anyone used these two parts from advance adapters? First is a 6 bolt to four bolt adapter with a vss. Part # 50-0405. http://www.advanceadapters.com/produ...onadapter-kit/ The second is a spacer to take up the shaft length. Part #50-8505. http://www.advanceadapters.com/produ...with-gm-700r4/ Ive got the parts sitting on the shelf in the shop. This will put the T-case into the stock position and move the motor forward a bit. Other than having to trim the trans shaft about a 1/2 inch its bolt in. Ive seen this bolted together on a friends rig, but yet to go down the road.
Last edited by SlowGreen71; 01-06-2018 at 08:09 AM. |
|
|
|
01-09-2018, 01:44 AM
|
#2 |
|
Senior Member
Join Date: Mar 2004
Location: Lee's Summit, MO (KC)
Posts: 742
|
Re: 4l60e to np205 a little easier
__________________
-Keegan- '72 Jimmy 4x4 - 5.3/4L65E/NP205 swap http://67-72chevytrucks.com/vboard/s...d.php?t=663780 |
|
|
|
|
01-11-2018, 01:57 AM
|
#3 |
|
Registered User
Join Date: Oct 2012
Location: foresthill. california
Posts: 20
|
Re: 4l60e to np205 a little easier
I the six to four bolt adapter, short output shaft. Then used the stock cost iron mount.
|
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
