Plug Wires

[mongocanfly]

im going to relocate my coils to the back of the engine...for those that have done this what are the better ones to use..im guessing there are some kits for this...id like to use 10mm wires if possible

[ls1nova71]

D7I used an 8mm Taylor cut to fit set made for an LT1. The LT1 has the same ends on the Optispark as an LS coil, unlike the older HEI wires. Depending on how you mount your coils you may need either straight or 45* ends. The Taylor numbers are 46052 for the straight and the 45 deg version is 46069.

[jjzepplin]

Originally Posted by ls1nova71

D7I used an 8mm Taylor cut to fit set made for an LT1. The LT1 has the same ends on the Optispark as an LS coil, unlike the older HEI wires. Depending on how you mount your coils you may need either straight or 45* ends. The Taylor numbers are 46052 for the straight and the 45 deg version is 46069.

I absolutely love what has been done to that engine. I have a 99 Trans Am with a T56 I am thinking of putting in my 72 Blazer and would like to know what intake is on that marvelous unit. I have just spent hours reading the signature threads and dang you guys are just masters!

[mongocanfly]

Thanks Eric !!....I'll check them out....I had forgotten about taylor...

[sprint_9]

I used MSD 8.5's. The kit I got was LS specific and came with either 90's or a straight/multi angle up to roughly a 45 degree for the plug side. I believe only 45's for the coils, but cant remember for sure now. Havent ran it yet, but i like them based on looks.

[mongocanfly]

Thanks sprint..those look good..

[mongocanfly]

Zep..that intake looks just like the one I have..If so its a holley 300-137....you would also need the Holley fuel rails....dayj1 did a great job on his and I'm kinda following what he did..http://67-72chevytrucks.com/vboard/s...ght=Skin+a+cat