Linkage between NP205 shifter & rail differences? - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Toro · 01-08-2019, 06:55 PM

I've seen two types of linkage used to connect the shift lever and the rail on the NP205. One is a flat piece with an angle bent into it, and the other is a round piece with each end turned. Were these used during different model years?

**Blazerowner** · 01-09-2019, 02:37 PM

I’ve never seen the flat one. Does it have the lugs with the pin in it? Looks like there’s a lug on the shifter.

01-08-2019, 06:55 PM	#1
Toro Registered User Join Date: Nov 2018 Location: Huntsville, AL Posts: 341	Linkage between NP205 shifter & rail differences? I've seen two types of linkage used to connect the shift lever and the rail on the NP205. One is a flat piece with an angle bent into it, and the other is a round piece with each end turned. Were these used during different model years? Attached Images

01-09-2019, 02:37 PM	#2
Blazerowner Senior Member Join Date: Apr 2006 Location: Yuba City, Ca Posts: 1,969	Re: Linkage between NP205 shifter & rail differences? I’ve never seen the flat one. Does it have the lugs with the pin in it? Looks like there’s a lug on the shifter. __________________ Kirk 72 Blazer CST 4wd highlander

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.