|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
|
|
03-26-2019, 12:30 PM
|
#1 |
|
Registered User
Join Date: Dec 2011
Location: Boise, Idaho
Posts: 596
|
ball joint lbs on pull scale
Hello all,
I am going back over my front end. I get a little "memory steer". When i rebuilt the front end I remember testing how many pounds of force require to rotate the outer c. Everything checked out during the install, but I can not find the specification of how many pounds it should be. Something is a little tight and i want to double check. Thanks, Chris |
|
|
|
03-26-2019, 01:05 PM
|
#2 |
|
Registered User
Join Date: May 2012
Location: horseheads,ny rust belt
Posts: 2,794
|
Re: ball joint lbs on pull scale
25 lbs i think pulling with a fish scale in the tie rod hole.
also verify the u-joint on the axle is not frozen up . jack up front end and turn the wheel . then try and spin the tire . if the joint is frozen or sticking it will be hard to spin the tire.
__________________
77-k30lb BIG truck build . 87-k30lb budget beater build . 85-k30lb the plow machine build . 85-c10sb summer fun toy . ----------------------------- HOLLEY SNIPER efi = worst case of p.i.t.a i ever had . EDELBROCK pro flo 4 = best deal going so far . love my setup works great. |
|
|
|
|
03-28-2019, 06:01 PM
|
#3 |
|
Registered User
 Join Date: Jun 2016
Location: Phoenix, AZ
Posts: 574
|
Re: ball joint lbs on pull scale
Not enough caster will cause that as well.
__________________
87 R30 CC Dually, TBI 454, NV4500, zero rust barn find 87 Jeep Grand Wagoneer, 6.5 turbodiesel, 700R4 |
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
