temp sender - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Patch · 04-04-2004, 07:50 PM

Hi all.....just replaced my temp sender after a wire repair...and now after my engine gets to operating tempature...the gauge pegs out. If this sending unit was for a truck with lights verses gauges...would this happen? Thanks.....

JimKshortstep4x4 · 04-04-2004, 08:11 PM

It sounds like you may have a bad sensor. Does it read while warming up?

One for a light could do what you are seeing but the engine would be hot for that to happen as the light is turned on when the engine is hot.

Jim

04-04-2004, 07:50 PM	#1
Patch Senior Member Join Date: Jul 2002 Location: Oak Harbor, WA Posts: 709	temp sender Hi all.....just replaced my temp sender after a wire repair...and now after my engine gets to operating tempature...the gauge pegs out. If this sending unit was for a truck with lights verses gauges...would this happen? Thanks..... __________________ Patch

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

04-04-2004, 08:11 PM	#2
JimKshortstep4x4 Senior Member Join Date: Jul 2001 Location: Muskegon,MI,USA Posts: 6,026	It sounds like you may have a bad sensor. Does it read while warming up? One for a light could do what you are seeing but the engine would be hot for that to happen as the light is turned on when the engine is hot. Jim



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.