air bag plumbing help

[MEANGREEN70]

I would like to get help from you guys on the do's and dont's when running the pluming for my air bag system. I would like the lines to go throu the frame in the front, but dont know where i can get fitting for that. the back i have taking care off. I will post pic soon, so you guys can tell me what you think. thanks

[el curioso]

Avoid exhaust and sharp edges . Gromets are verry use full but bulkheads are better IMO. Secure lines using lock ties or opressors cuz viration in even the softest (SPELL?) area is killer. Go over every thing with soap & water to check for leak's. Avoid all moving parts.

[N2TRUX]

If your running plastic line, keep it well away from any heat source. Even getting too near the catalytic converter will cause the line to blow. You can protect it with grommets, split wire loom, or split rubber hose where it can't burn, or rub through.

[MEANGREEN70]

El curosio and N2TRUX thanks for the info, if anybody has more it will be appreciate. Here are some pics of my project under constration, if you guys see anything that wrong with what ive done so far, i would appreciate any help that you can give me. Everything that you see in the pics is from asking questions and by looking other people do it, so as you can see i am learning as i go.

[N2TRUX]

The only thing I see that you should be planning out now is the exhaust. If you mock it up now, you can route your lines well away from any potential heat source.

Beyond that, everything is looking good. That's going to be a sweet stepper when you get done. Don't forget when setting up your suspension that real hot rods have rake....

[MEANGREEN70]

couples more pics.