Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
|
07-10-2006, 08:43 PM | #1 |
Senior Member
Join Date: Jan 2004
Location: SE Ohio
Posts: 1,121
|
Question on blazer tank install
Parted out a 90 suburban and pulled the tank out of the rear between the rails had been a tbi setup can this be grafted into a 67-72 truck without too much of a head ache or is just going with another tank a better plan new to this and thought I would ask the pro's thanks for looking at this post Mike
__________________
hav'n fun be'n me |
07-12-2006, 11:24 AM | #2 |
Registered User
Join Date: Jul 2005
Location: Nanaimo, BC
Posts: 76
|
Re: Question on blazer tank install
Hi Mike
I too, would like to find a baffled F.I. fuel tank that would fit nicely into a 67-72 Blazer. I have a 1990 350 looking for home and I thought it might end up in my 72. I do not think however the Suburban tank will fit easily. Chevrolet Suburban Part Number: GM14C 1986-91 Fuel Tank 31 Gal with F.I. Capacity: 31 Gallons/118 Liters Dimensions: 28-3/4 X 28-1/8 X 12-3/4 inches Depth of bottom half - 5-1/2 The 72 Blazer tanks are rectangular Capacity: 21 gallon Dimensions (my measurements): 28-3/4 wide (side to side) X 18-3/4 long (front to rear) X 14 inches high Depth of bottom half - 7 Apparently the newer blazer tanks are baffled and the same size as the Suburban but not as deep: Chevrolet Blazer Full Size 1987 Part Number: GM15C 1987 Fuel Tank 25 Gal with F.I. Capacity: 25 Gallons/95 Liters Dimensions: 28-3/4 X 28-1/8 X 10-3/4 inches Depth of bottom half - 3-1/2 inches I hope someone knows of a solution for us! Tim |
07-12-2006, 07:29 PM | #3 |
Active Member
Join Date: Jun 2000
Location: Pottstown, PA
Posts: 197
|
Re: Question on blazer tank install
If you are doing a FI swap and just want the tank for the baffling, the other option is to install an in tank fuel pump complete with its own baffle. www.tanksinc.com makes them. That's what I used on mine. The only problem I had to fix was that the upright was a bit too short and I had to put a short extension on it. Otherwise..works great.
__________________
The rides: '72 Blazer 350/4spd/Tuned Port Injection '69 Firebird 400/4 speed 2001 Dodge Dakota Sport 4X4/4.7L V8/5 spd/Headers/Jet Chip, etc. Daily Driver 2002 Airborne Zeppelin (roadbike) Titanium frame/Campy Chorus 2004 Filippi Italia S (rowing shell) |
07-19-2006, 11:00 PM | #4 |
Senior Member
Join Date: Jan 2004
Location: SE Ohio
Posts: 1,121
|
Re: Question on blazer tank install
Thanks for the replies guys I am still in the figuring stage and will find something that will work just want a clean installation and do not want a cell in the bed just not my thing later Mike
__________________
hav'n fun be'n me |
07-20-2006, 08:47 AM | #5 |
Tpi72Blazer
Join Date: Sep 2004
Location: Colorado
Posts: 92
|
Re: Question on blazer tank install
I used a tank from a late 90's Tahoe when I did my TPI swap. It is baffled and had the high pressure internal fuel pump for the Vortec engine. All I had to do was swap out the fuel pump for the TPI application.
__________________
Indian - the other money pit |
07-20-2006, 05:02 PM | #6 |
Registered User
Join Date: Jan 2005
Location: Colorado Springs
Posts: 693
|
Re: Question on blazer tank install
I have also looked at doing this and what I found was that I would have had to cut the rear frame support out and weld in a new support that had a mounting flange 180* routated compared to the factory support. The reason was becasue the tank would be too close to the rear diff. Also the next cross support would also have to be moved. It would have been easy for me because I could have made it fit with some fabrication but decided not to becasue of the time involved. For sure without modifing the rear cross support the tank is too long it needs to be mounted further back then the factory cross support would allow. As far as the gas fill location being different I felt that it was in a good center point in the tank that the tank could be turned around easily.
Good luck
__________________
1971 GMC K1500 SWB Fleetside, 4" skyjacker softride and, 14 Bolt FF, HD Dana 44 4.10's 1970 K5 TBI conversion lifted etc SOLD 1968 C20 camper truck SOLD “To ban guns because criminals use them is to tell the innocent and law-abiding that their rights and liberties depend not on their own conduct, but on the conduct of the guilty and the lawless.” Jeff Snyder |
07-21-2006, 12:48 PM | #7 |
The Blazer King
Join Date: Sep 2000
Location: Valrico, Fl (Tampa)
Posts: 1,212
|
Re: Question on blazer tank install
Get one from from Fuelcellguy. He can make you any size with baffling.
__________________
72 2wd Blazer. Its the superbichinest, megacoolinest, superflowinest. |
Bookmarks |
|
|