|
|
|
07-22-2006, 06:49 PM
|
#1 |
|
Registered User
Join Date: Apr 2006
Location: Hockinson, Washington
Posts: 115
|
Steering Column
Got a 68 that was a former 3 on the tree truck, currently running four on the floor. The original column is still intact and in the truck, would I be able to use it to column shift an automatic tranny? (Of course with new linkage at the very least.) Is this even possible?
__________________
1968 Chevrolet C-10, 2WD, Longbox, Vortec 350, 700R4, 3.73 gears Good judgment comes from experience, and experience, well......that comes from bad judgment. 1968 Chevy C-10 "Longshot": Bought used from my Uncle George in 1994 and proceeding to beat the hell out of it for 4 years. Sold it. Bought it back, dumped an ungodly amount of money into it since then. |
|
|
|
07-22-2006, 07:22 PM
|
#2 |
|
Senior Member
 
Join Date: Dec 1999
Location: Spring Valley, Ca.
Posts: 1,136
|
Re: Steering Column
No. You'll have to swap an automatic column in if you want to run an auto trans. Check out the FAQ's that topic should be really well covered! Good luck.
__________________
Smitty '71 Short Fleetside Spring Valley, Ca. |
|
|
|
 |
| Bookmarks |
|
|
Hybrid Mode
