|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
|
|
12-23-2006, 04:17 PM
|
#1 |
|
Registered User
Join Date: Jan 2006
Location: Morro Bay C.A
Posts: 179
|
hub/wheel bearing assembly
hi,
i am having a lot of trouble triying to get this hub off of the spindle on my 70 c ten. it is fron drums i have all the harware removed and the spindle nut off and it wont budge. i have tried even using a large claw puller... any ideas... the wheel bearings inside are bad but not frozen. it should come out.  
__________________
'69 C10 SWB 350 edelbrock int/carb .420 .442 cam 700r4 70 lwb c10 work truck 250 I6 with two inch lift springs and a two inch bodylift and 33/12.5s |
|
|
|
12-23-2006, 04:27 PM
|
#2 |
|
Registered User
Join Date: Dec 2004
Location: El paso, Tx.
Posts: 428
|
Re: hub/wheel bearing assembly
I installed the wheel and used it for leverage, try heating the bearing, The other way known to me is a BFH
__________________
1969 Chevy C-10 350/700r4 Last edited by el curioso; 12-23-2006 at 04:28 PM. |
|
|
|
|
12-23-2006, 08:29 PM
|
#3 |
|
Registered User
Join Date: Jan 2006
Location: Morro Bay C.A
Posts: 179
|
Re: hub/wheel bearing assembly
thanks i heated it up with the torch and used the puller at the same time and it finally came off thanks
__________________
'69 C10 SWB 350 edelbrock int/carb .420 .442 cam 700r4 70 lwb c10 work truck 250 I6 with two inch lift springs and a two inch bodylift and 33/12.5s |
|
|
|
|
| Bookmarks |
|
|
Hybrid Mode
