Pulled the Interior this past weekend need suggestions!

[blazn79]

So I got around to doing some work on my 79' this past weekend because of the nice weather, I don't have a garage and w/ the very snowy winter couldn't do much of anything blazer related! So I was playing around w/ the rear latch last week w/ the key and found out you can lower the glass by turning it to the right, I knew it had a power rear glass because it has the switch on the dash but doesn't work, anyways so I put the taigate down for the 1st time since I owned it, pulled the rear sill trim off and checked under the carpet to see how clean it was and it was very clean, just a little surface rust were the screws go on the right side of the rear sill trim, then went to the front and pulled off the door sill trim pulled up the rug and padding it was
moist and lots of surface rust so I stipped out everything to dry it out
and here's what I have, there are a few 1/4 - 1/2 holes in verious areas and
would like to know the best way to patch them and refinish the drivers/pass floor?


Thanks, Harry.FOR LIFE!

[tvblazer78]

Looks like it has been wet for a long time. They are every small so I would not weld any new parts in, put maybe someone can help with what to us on the floor. Lookin good..

[factory2wdblazer's]

don't look that bad i would weld those hole's up and smootin out and sould be good to go. inless you want to cut it out and put some new floor pan's in.....as for a rust treatment there is few out on the market

[blazn79]

Thanks Guys, I think I will go that route sorta, I'll probably get some scrap sheet metal from my buddy's sheet metal shop and weld in patches in those spots and then get some Eastwood rust converter and encapsulator and do the whole floor pan.

What do guys think of or know anything about that Lizard skin stuff that Eastwood sells for coating interior floors?

What gage sheet metal should I be looking for?

H.FOR LIFE!

[factory2wdblazer's]

sound's like a good solid plan.

[tvblazer78]

What gage sheet metal should I be looking for?


I would use something under 20 gage and that would work just fine.. Good luck.

[blazn79]

Cool, thanks Trav!

H.FOR LIFE!

[rcfatcat]

your lucky man i have a 78 k5 blazer and a 78 gmc jimmy both with floors that have rotted through to the point where there are soccer ball size holes i would definitly go the route of making tiny patch panels and hitting the rest with eastwood product

[BIG_J]

how much is the blazer lowered? i like how it sits i also have a 79 and hopefully lowering it soon.

[blazn79]

BIG J, the back has a flip and a c-notch and that gave it about a 7" drop
from stock, the front has DJM 3" drop control arms w/ 2" drop coils which
accually gave it a 5.5 drop from stock!

FOR LIFE!

[tvblazer78]

Very nice man. Looks way better then it did..

[blazn79]

Thanks Trav, a little @ a time its getting there!


H.FOR LIFE!