Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
|
07-26-2009, 01:26 AM | #1 |
Cradle Robber
Join Date: May 2009
Location: Lily Lake,Illinois
Posts: 774
|
Tahoe interior questions
I ahve a 90 fullsize Jimmy and I just scored some 2002 Tahoe front and rear seats from the boneyard.I also have a set of 2001 third row seats from a Tahoe that was repoed from one of my roomates.I'm guessing that the front seats will be pretty easy to install with little mods,but my question is about the back seats.Will they just bolt in?Will the third row seats work better?To make a long question short,what mods will need to be done to make the rear seats or the third row seats work in my Jimmy?
__________________
"The problem with the world is that everyone is a few drinks behind." Humphrey Bogart "Hippies.They're everywhere.They wanna save the earth,but all they do is smoke pot and smell bad."Eric Cartman "Think about how stupid the average person is,and realize half of them are stupider than that."George Carlin |
07-26-2009, 08:32 PM | #2 | |
Low & Fast!
Join Date: Jan 2007
Location: Knoxville, TN
Posts: 3,110
|
Re: Tahoe interior questions
Quote:
I did the same thing to mine, the front is easy I think I just made 3 new holes and put plates on the floor just to make it stonger. The back seat I had to take it all the way to the frame and make new plates to go from the frame of the seat to the floor. I did this for one I did not want to cut my floors up and to make the seat set lower then it would being stock. Take a look at this and it may help. http://67-72chevytrucks.com/vboard/s...d.php?t=269365
__________________
Last edited by tvblazer78; 07-26-2009 at 08:34 PM. |
|
Bookmarks |
|
|